Crown Offroad - Dual In-Dash Switch Panel
Dual In-Dash Switch Panel
Looking to add a few extra electrical accessories to your vehicle and need a dual switch panel? This switch panel was designed to fill the small pocket on the dash of your 2009-2014 F150 or Raptor.
The panel is made from laser cut 5052 aluminum and is then powder coated black for years of worry free use. Each switch panel comes with your choice of red or blue contura style LED switches. The panel attaches using commercial grade double sided tape for easy installation and removal should you decide to take the panel out. Wiring the switches requires a small hole be drilled in the side of the plastic pocket (this can be achieved by dropping the glove box all the way down and using a small drill, drilled from the backside of the dash to allow for wiring).
Manufactured in the USA!
California Residents: Prop 65 WARNING: This product MAY contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information, visit www.P65Warnings.ca.gov
California Residents: CARB WARNING: OffroadAlliance.com will not ship any products that are not CARB approved to California. This only affects CARB related products such that affect car performance and emissions where CARB approval is required.
I haven’t installed it yet but the switches and panel are well built and will look as if they were “factory”
I would have no problem purchasing it again and Ordering from Offroad Alliance They were a good company to deal with
One switch arrived with a very obvious 1/2 inch scratch in the indicator lamp area, and the mounting tape is poor quality. I replaced with 3M Emblem and Trim Mounting Tape.
We Also Recommend
BuiltRight Industries - Dash Mount Kit - 2010-2020 F150 & Raptor, 2017-2020 Super Duty F250/F350
BuiltRight Industries - Rear Seat Release Kit - 2010-2020 F150 & Raptor, 2017-2020 F250/F350/F450