Krazy House Customs - LCA Support Kit and Slot Eliminator - 2017-2020 Raptor

  • $299.00

LCA Support Kit and Slot Eliminator

We have fixed more than a few bent LCA pockets which is what inspire this kit. The rear pockets are very prone to bending on both GEN1 and GEN2 due to lack of support on the back of the pocket along with the stock rubber bushing deflection during a impact allowing in to easily bend the rear pocket. 

This kit not only adds a support to the rear pocket but all the mounts. It also locks the lower control arms in the outer most position (recommended), center position or the holes can be slotted so you can still adjust the alignment from the lowers.

It is highly recommend locking the lowers in place and using adjustable upper control arms if you are running offroad.

  • Bolt in design can also be welded
  • Works with stock swaybarM
  • ade from 3/16 steel plate
  • Includes all hardware

California Residents: Prop 65 WARNING: This product MAY contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information, visit www.P65Warnings.ca.gov

California Residents: CARB WARNING: OffroadAlliance.com will not ship any products that are not CARB approved to California. This only affects CARB related products such that affect car performance and emissions where CARB approval is required.

Snap Finance - Apply Here

We Also Recommend

★ Our Reviews

Let customers speak for us

1303 reviews
95%
(1234)
5%
(60)
1%
(8)
0%
(1)
0%
(0)

Great, came with a wiring harness made it almost plug and play. Really bright, and good looking designs. Looks good on my Ford Raptor.

Awesome service!

The entire team at ORA will take care of your off road needs. Great job guys.

Great lights

Overall awesome lights, pretty good cutoff and great range down low!

Delivered on the promise!

Really happy with the install. With the frame, the lights look OEM, and definitely secure including the light bumper guards which I think are needed to avoid snow and crap all over the lights. Install before the lights! Had to do a bit wrangling with the rubber gasket cos the part was too big (offroad sent a replacement immediately). However as a first timer installer I have to say it took a lot of tools, patience, crawling (and swearing), but very doable. Watch the videos, and take your time. I have the four BD SAE squadrons and the S1 cornering on different switches on my 2020 raptor. Bright enough for most in road or offroad I need. Tip: buy lots of quality pull ties, heat crimps, insulation tape. The harness is the best I’ve seen - expensive but worth it to me

works perfectly. Worth the money

Extractor worked perfectly. Glad I bought it

Customers rate us 4.9/5 based on 1303 reviews.