19-23 Ranger Start/Stop Eliminator

The Auto Start/Stop system is simple. It automatically shuts off the engine when the vehicle is at rest (but not in park) to cut fuel use and eliminate idle emissions. It then restarts the engine automatically when the driver lifts off the brake to get going again.

Note: this is sometimes confused with the Auto Engine Idle Shutdown (AEIS) feature on many vehicles. The idle shutdown system shuts off a vehicle that is idling while parked after 30 minutes.

Features

Simple plug n' play install - No tools needed!
Memorizes start/stop system
Will not void warranty
Maintains remote start
Emissions compliant

Compatibility

2019, 2020, 2021, 2022 & 2023 Ford Ranger

Emissions Compliance

START/STOP ELIMINATOR TECHNOLOGY. Our Start/Stop Eliminator is an intelligent plug & play device. It simply remembers when you turn the auto start/stop feature on or off and works to retain your preference automatically. This device eliminates the need to push the button to disable auto start/stop feature every time you get in the vehicle. Unlike other technologies, the Start/Stop Eliminator doesn't affect or change any of your vehicle's programming. Nor does this device change the emissions output of a vehicle. The Start/Stop Eliminator ONLY provides the user the ability to either keep the start/stop feature on or off without the feature resetting after each ignition cycle. If the device is removed, the vehicle will go back to stock behavior.

START/STOP ELIMINATOR VS. THE CLEAN AIR ACT. The Clean Air Act deals directly with the emissions and fuel aspect of air pollution. There are set laws and enforcements to ensure all standards are met throughout the nation. The Start/Stop Eliminator technology does not override any programming nor does it change the emissions output on the vehicle. It only "presses the button" for the user each key cycle if that was the preferred state. The Start/Stop Eliminator device is fully compliant with the Clean Air Act under the provisions of the EPA's Tampering Policy.

Installation

Simply insert between factory wire harness and back of diagnostic connector housing below the steering wheel (gateway module).

Frequently Asked Questions

Will it work? The start/stop eliminator had been tested on on all the models and years listed above.
Issues or loss of functionality? It will not cause any issues or impact any factory features.
Vehicle Warranty? The start/stop eliminator will not void your vehicle warranty.
Re-enable Start / Stop? Yes, simply use the auto start/stop button on your dash like normal.
Remote start still work? This will NOT impact your remote start.