G Screen Monitoring System for Gen 3 Dual Battery Systems

Keep an eye on the status of your dual battery system

Monitors voltage levels of both batteries.

Remote status indicator - shows if the batteries are connected or disconnected.

Remote boost button - jump start the engine from inside the cab if your cranking battery is dead.

Background changes color to visually show your battery status at a glance

Green - both batteries are fully charged, and they are connected together

Yellow - the batteries are below 12.7v, and they are disconnected

Red - at least 1 battery is below 12v. The screen will blink red a few times per minute to get your attention

Background light turns off after 45 seconds of inactivity

Preserves battery power

No glare while driving at night

Voltage and status is still visible, but without the backlighting

Main Battery Voltage. Holding this screen down for 3 seconds will turn off the screen. Tap once to turn the screen back on.

Aux Battery Voltage. Holding this screen down for 3 seconds will turn off the screen. Tap once to turn the screen back on.

Status Screen. AUTO mode - the system will automatically connect / disconnect the batteries based on the voltage levels

AUTO OFF: The batteries are isolated from each other
AUTO ON: The batteries are connected together

Hold screen down for 3 seconds to access the Boost menu. When the background turns white, tap the screen to cycle through the menu. Stop tapping to select the desired mode.

Selecting Boost On will manually connect the batteries together. Use this to jump start from the second battery if your main battery is too low to start the engine. They will remain connected until you select Boost Off or Auto mode. NOTE all electrical circuits in the vehicle will run from both batteries in this mode.

Selecting Boost Off will manually separate the batteries. They will remain separated until you select Boost On or Auto mode. NOTE your Aux battery will not be charged by the alternator while in this mode.

Selecting Auto On will set the system to Automatic mode.

This screen shows the Air Pressure in your on-board air tank if you have the optional Digital Air Pressure Sensor kit installed without the sensor installed, this screen will not be displayed.

This screen shows the Firmware Version. Holding this screen down for 3 seconds will enter the contrast adjustment menu, allowing you to tap through 5 levels of contrast for optimal viewing.

Kit Contents

G Screen

Interface Module

Ribbon Cable

Wire Harness

Panel Cutout Template

Screen measures approximately one cubic inch. Compact size makes it easy to mount anywhere. Includes a 11 ft. wiring harness for simple, clean installation. Software upgradeable for future features.

Add the optional Genesis digital air pressure sensor to monitor the PSI level in your on-board air system. Screw the sensor into an available 1/4" NPT port on your air tank or manifold. Attach the waterproof cable to the sensor, and route the cable to the G Screen. Plug the other end into the interface module. The G Screen automatically detects the sensor and adds a new screen showing the PSI level in your tank, from 0-150 PSI. No air hoses to run, no wiring to figure out!