BajaRack 10+ 4Runner Roof Rack: Standard Basket (long, sunroof cutout, mesh floor)

10+ 4Runner Roof Rack: Standard Basket (long with sunroof cutout & mesh floor)

This low-profile Toyota 5th Gen 4Runner roof rack has a sunroof cutout and mesh flooring. It is built with US-Made, cold-rolled steel tubing and best-in-class powder coating to ensure quality.

This standard long rack (with mesh floor) will add much-needed cargo space to your vehicle to tackle your adventures. The installation is done directly to the body frame without drilling, the outside frame is made of 1" tubing, and the flooring with 1/2" cold roll steel tubing and 3/4" steel mesh. This rack was designed around the 4x factory mounting positions on the roof of the vehicle without obstructing the operation of the sunroof, there is a cutoff on the floor of the rack to avoid interference with the roof antenna. No drilling is required.

Tech Specs

• Material and Thickness: 1 in., 3/4 in. and 1/2 in. Steel tubing; 3/4 in. Steel mesh


• Top Wind Deflector: 0.062 in., 5050-H32 Aluminum


• Finish: Epoxy primer (rust inhibitor) with black powder coating


• Rack Weight: 95 lbs.


• Load Capacity: Dynamic (while driving) 300 lbs.; Static 600 lbs.


• Measurements: 91 x 5 x 46 in.


• Total Height (top of roof to top of rack): 8.25 in.


• Mounting Method: Roof mounts (2x front adjustable brackets and 4x support brackets)

Rack Includes

• Mounting Brackets


• Stainless Steel Hardware


• Aluminum Wind Deflector

IF YOU BUY A RACK + LADDER PLEASE CHECK THIS NOTE

Before you install your new BajaRack ladder check the gap on top of the hatch it needs to be 5/16" to 3/8", if the upper top of the ladder does not enter the gap on the hatch do not install, and check the gap clearance with a dealer or shop.

EXTREMELY IMPORTANT NOTE

Please verify the lip (edge) measurement before purchasing or installing your ladder, the standard dimension is between 0.1" and 0.2" if this dimension is larger than 0.2" don't install the ladder, Toyota in some models applies more sealant in this area that can cause the ladder to not fit.